Sunroof Motor: Installation
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When installing the sunroof motor, be careful not to move the cable assembly.
- Install the motor assembly and connect the connector.
Tightening torque:
3 N.m (0.3 kgf-m, 2.2 ft-lb)
- Install the light assembly map. Ref. to LIGHTING SYSTEM>SPOT MAP LIGHT>INSTALLATION
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
- Perform the initialize operation. Ref. to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>SUNROOF CONTROL SYSTEM>OPERATION>INITIALIZE OPERATION
- Check the operation of sunroof by following the table below.
Operation Switch position (1) Completely close the glass lid. Close (2) Tilt up the glass lid to the top position. Tilt up (3) Completely close the glass lid. Tilt down (4) Completely open the glass lid. Open (5) Completely close the glass lid. Close