Drive Cycle A
WARNING: This page is about a different variant/trim than selected.
| Unit of measure | Item | Condition |
|---|---|---|
| P0601 | Internal Control Module Memory Checksum Error | Perform the drive cycle A twice. |
| P0604 | Internal Control Module Random Access Memory (RAM) Error | Perform the drive cycle A twice. |
| P062F | Internal Control Module EEPROM Error | Perform the drive cycle A twice. |
| P0712 | Transmission Fluid Temperature Sensor "A" Circuit Low | - |
| P0842 | Transmission Fluid Pressure Sensor/Switch "A" Circuit Low | - |
| P0843 | Transmission Fluid Pressure Sensor/Switch "A" Circuit High | - |
| P0890 | TCM Power Relay Sense Circuit Low | - |
| P0962 | Pressure Control Solenoid "A" Control Circuit Low | - |
| P0963 | Pressure Control Solenoid "A" Control Circuit High | - |
| P0966 | Pressure Control Solenoid "B" Control Circuit Low | - |
| P0967 | Pressure Control Solenoid "B" Control Circuit High | - |
| P160A | Random Access Memory (RAM) Error | Perform the drive cycle A twice. |
| P2530 | Ignition Switch Run Position Circuit | - |
| P2763 | Torque Converter Clutch Pressure Control Solenoid Control Circuit High | Perform the drive cycle A, then perform the drive cycle C. |
Diagnostic procedure:
- Start the engine.
- Depress the brake pedal and move the select lever to each range at an interval of five seconds.NOTE: Move the select lever in the following order: "P" → "R" → "N" → "D" → "N" → "R" → "P".