FixVault
Home › Subaru › 2021 › WRX Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 8 (Engine Mechanical System (2.5L)) › Timing Belt Cover › Installation

Timing Belt Cover: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install front timing belt cover (E).

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  2. Install the timing belt cover LH (D) together with the engine harness stay (C).

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  3. Install the timing belt cover RH (B) together with the engine harness cover (A).

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

    G10265329Courtesy of SUBARU OF AMERICA, INC.
  4. Secure the engine harness to the engine harness stay using the clip.
    G10264720Courtesy of SUBARU OF AMERICA, INC.
  5. Install the crank pulley. Refer to MECHANICAL(STI)>CRANK PULLEY>INSTALLATION .
  6. Install the secondary air pump. Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (STI)>SECONDARY AIR PUMP>INSTALLATION .
  7. When working on the vehicle
    NOTE: When working on the vehicle, perform the following steps also.
    1. Install the front under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
About FixVault