Section 1 (Engine Control System (Diagnostics) (2.0L) - Introduction)

• Basic Diagnostic Procedure
  • Procedure
    • Engine
• Check List for Interview
  • Check
    • Check List No. 1
    • Check List No. 2
• General Description
  • Caution
  • Inspection
    • Notes
    • Battery
    • Engine Ground
  • Note
  • Preparation Tool
    • Special Tool
    • General Tool
• Electrical Component Location
  • Location
    • Control Module
    • Sensor
    • Solenoid Valve, Actuator, Emission Control System Parts And Ignition System Parts
    • Transmission
• Engine Control Module (ECM) I/O Signal
  • Electrical Specification
• Data Link Connector
  • Note
• General Scan Tool
  • Operation
    • How To Use General Scan Tool
    • Mode $01 (Current Powertrain Diagnostic Data)
    • Mode $02 (Powertrain Freeze Frame Data)
    • Mode $03 (Emission-Related Powertrain DTC)
    • Mode $04 (Clear/Reset Emission-Related Diagnostic Information)
    • Mode $06 (Request On-Board Monitoring Test Results For Continuously Monitored Systems)
    • Mode $07 (Initial Emission-Related Powertrain DTC)
    • Mode $08 (Request Control For On-Board System, Test, And Component)
    • Mode $09 (Request Vehicle Information)
    • Mode $0A (Emission-Related DTC (With Permanent Status))
• Subaru Select Monitor
  • Operation
    • How To Use SUBARU Select Monitor
    • Display Current Engine Data
    • Display Of Engine Freeze Frame Data
    • V.I.N Registration
• Read Diagnostic Trouble Code (DTC)
  • Operation
    • SUBARU Select Monitor
    • General Scan Tool
• Inspection Mode
  • Procedure
• Drive Cycle
  • Procedure
    • Notes
    • Preparation For Drive Cycle
    • Drive Cycle A
    • Drive Cycle B
    • Drive Cycle E
    • Drive Cycle F
    • Drive Cycle H
    • Drive Cycle I
    • Drive Cycle J
    • Drive Cycle N
    • Drive Cycle O
    • Drive Cycle P
    • Drive Cycle Q
    • Drive Cycle R
    • Drive Cycle S
    • Drive Cycle T
    • Drive Cycle U
    • Drive Cycle W
    • Drive Cycle X
    • Drive Cycle Y
    • Drive Cycle Z
    • Drive Cycle Aa
• Clear Memory Mode
  • Operation
    • SUBARU Select Monitor
    • General Scan Tool
• Active Test
  • Operation
• Malfunction Indicator Light
  • Procedure
  • Activation Of Malfunction Indicator Light
  • Malfunction Indicator Light Does Not Come On
  • Malfunction Indicator Light Does Not Go Off
• Diagnostics for Engine Starting Failure
  • Procedure
  • Starter Motor Circuit
    • Model Without Push Button Start
    • Model With Push Button Start
  • Check Power Supply And Ground Line Of Engine Control Module (ECM)
  • Ignition Control System
  • Fuel Pump Circuit
  • Fuel Injector Circuit
• List of Diagnostic Trouble Code (DTC)
  • List