FixVault
Home › Subaru › 2021 › WRX STI › Repair and Diagnosis › Transmission › Manual Trans › Manual Transaxle & Differential (TY856) › Neutral Position Switch › Installation

Neutral Position Switch: Installation

  1. Install the neutral position switch.
    NOTE: Use a new gasket.

    Tightening torque: 

    32 N.m (3.3 kgf-m, 23.6 ft-lb)

  2. Connect the connector and clip of the neutral position switch.
  3. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
About FixVault