Rear Finisher Assembly: Installation
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- Install the finisher assembly rear.
Tightening torque:
4.5 N.m (0.5 kgf.m, 3.3 ft.lb)
- Install the garnish assembly rear gate.
Tightening torque:
4.5 N.m (0.5 kgf.m, 3.3 ft.lb)
- Install the motor assembly rear wiper, Ref. to WIPER AND WASHER SYSTEMS>Rear Wiper Motor>INSTALLATION .
- Install the sensor touch assembly. (Model with power rear gate)
- Install the cover rear gate. (Model without power rear gate)
- Install the trim panel assembly rear gate.
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .