Rear ABS Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be careful not to damage the sensor.
Do not apply excessive force to the sensor harness.

Install the sensor sub assembly rear.
NOTE: Check the identification (mark) on the harness to make sure there is no warpage. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>General Description>SPECIFICATION .

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)
Lower the vehicle.
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .