VDC OFF Switch: Inspection

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Measure the resistance between the VDC OFF switch terminals.

Preparation tool:

Circuit tester

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Standard
6 - 8	Switch OFF	1 MΩ or more
6 - 8	Switch ON	Less than 1 Ω

Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.

Terminal No.	Inspection conditions	Specification
1 (+) - 4 (-)	Apply battery voltage	Light ON

Replace the VDC OFF switch if the inspection result is not within the standard value.