Front Impact Sensor
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- Before installation, inspect the following items and replace any faulty part with a new part.
- Front impact sensor is free from damage.
- Connector is free from damage.
- Install the front impact sensor.CAUTION:
- Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.
- When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
Tightening torque:
13 N.m (1.3 kgf-m, 9.6 ft-lb)
- Do not reuse the bolt and nut.
- Install the air intake duct. (RH side only)
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .