Initialization Using The Power Window Switch (Rear Seat)

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Perform registration when any of the following procedures are taken.

With the ignition switch ON, when a power window is rolled up/down and then the power supply is cut. (This is because the positional information is updated at the moment the power window is moved after the ignition switch is turned ON.)
When regulator or regulator motor is replaced. (Registration is not necessary when the battery is replaced.)
1. Turn the ignition switch to ON.
2. Operate the switch - power window main or the switch - power window on the rear seat side in "DOWN" direction to fully open the glass assembly - rear door on the rear seat side. Once the window is fully opened, hold the switch for longer than one second.
  NOTE:
  - Wherever the glass is at any position, operate the switch in "DOWN" direction.
  - The operation can be done from both the switch - power window main and the switch -power window on the rear seat side.
3. Operate the switch - power window main or the switch - power window on the rear seat side, and check that the speed of automatic rolling up and down of the windows changes. Once the window is fully closed, hold the switch for longer than one second.
  NOTE: At this time, do not move the vehicle.
4. Operate the switch - power window main or the switch - power window on the rear seat side in "DOWN" direction to check whether the window fully opens properly. Also, operate the switch in "UP" direction to check whether the window fully closes properly.
  NOTE:
  - If the window does not fully open/close properly, repeat steps 1) to 4).
  - The operation can be done from both the switch - power window main and the switch -power window on the rear seat side.