Inhibitor Switch: Removal

NOTE: Do not turn the manual valve lever shaft before installing the inhibitor switch.
If the manual valve lever shaft is turned, it may be disconnected in the transmission.

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the center exhaust pipe. Ref. to EXHAUST (H4DO)>CENTER EXHAUST PIPE>REMOVAL .
Disconnect the select lever rod.

Courtesy of SUBARU OF AMERICA, INC.

Remove the bushing and spacer from the selector lever.

NOTE: Perform this procedure only when required.

Courtesy of SUBARU OF AMERICA, INC.

(A)	Spacer
(B)	Bushing
(C)	Selector lever

Remove the nut, spring washer, and selector lever.

Courtesy of SUBARU OF AMERICA, INC.

(A)	Nut
(B)	Spring washer
(C)	Selector lever

Disconnect the connector.

Courtesy of SUBARU OF AMERICA, INC.
Unlock the nut stopper.

Courtesy of SUBARU OF AMERICA, INC.
Remove the nut and the nut stopper.

Courtesy of SUBARU OF AMERICA, INC.

(A) Nut

(B) Nut stopper
Remove the inhibitor switch.

Courtesy of SUBARU OF AMERICA, INC.
Remove the seal material from the bolt holes in the transmission case and the bolt.