FixVault
Home › Subaru › 2022 › Outback Limited XT › Repair and Diagnosis › Transmission › Automatic Trans › CVT Transaxle System (Tr690) › Inhibitor Switch › Installation

Inhibitor Switch: Installation

  1. Temporarily connect the inhibitor switch, and connect the connector.
  2. Install the shifter arm and fix with a new spring pin.
  3. Connect the select cable to the transmission main body.
    CAUTION:

    Do not apply excessive load while holding the part (a). 

    G13951047Courtesy of SUBARU OF AMERICA, INC.
    NOTE:

    Set the washer before installing the snap pin. 

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

    G13951048Courtesy of SUBARU OF AMERICA, INC.
  4. Adjust the inhibitor switch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>INHIBITOR SWITCH>ADJUSTMENT .
  5. Release the shift lock and shift the select lever to the "P range". Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
About FixVault