Master Cylinder: Installation

Set the seat to the master cylinder.
CAUTION: Always use a new seat.
Install the hose bracket, clutch pipe, clutch hose, master cylinder, and seat as a unit.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Apply grease to the outer periphery of the clevis pin.
CAUTION: Always use a new clevis pin.

Preparation items:

Grease: NIPPON GREASE NIGTIGHT LTS No. 2 or equivalent

Courtesy of SUBARU OF AMERICA, INC.
Align the holes on the master cylinder lever and push rod, and install the clevis pin and snap pin.
NOTE: Insert the clevis pin from the left side of vehicle.
Using a new gasket, connect the clutch hose.
NOTE:
- Install the clutch hose while making sure that it hangs loose to the rear of the vehicle.
- Face the mark (a) of the clutch hose in the top direction.
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Bleed air from the clutch fluid. Ref. to CLUTCH SYSTEM>AIR BLEEDING>PROCEDURE .
Check the full stroke of the clutch pedal. Ref. to CLUTCH SYSTEM>CLUTCH PEDAL>INSPECTION .
Install the cover LWR driver INN and cover LWR driver OUT. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .