Automatic Transmission System: General Description: Preparation Tool: Other

	REMARKS
Circuit	tester Used for measuring resistance, voltage and current.
Caliper	Used for measuring the dimension.
Hexagon socket wrench (5 mm)	Used for removing and installing the overflow plug.
TORX® bit T55	Used for removing and installing the plug.
Caliper gauge	Used for measuring the inner diameter of the reverse clutch hub. Used for measuring the inner diameter of the forward clutch hub. Used for measuring the inner diameter of the rear planetary gear.
Cylinder gauge	Used for measuring the inner diameter of the front planetary gear.
Micrometer	Used for measuring the outer diameter of the intermediate shaft. NOTE: Used together with the V-block.
V-block	Used for measuring the outer diameter of the intermediate shaft. NOTE: Used together with the micrometer. Used for measuring runout of the intermediate shaft. NOTE: Used together with the dial gauge (spindle type) and the magnet stand.
Roller probe	Used for measuring runout of the drive plate. NOTE: Used together with the dial gauge (spindle type) and the magnet stand.
Rubber sheet Width x Height x Thickness Approx. 45 mm x approx. 45 mm x approx. 5 mm (Approx. 1.77 in x approx. 1.77 in x approx. 0.20 in)	Used for removing and installing transmission body. NOTE: Used by attaching to STAND ASSY (18632AA010) with double sided tape, etc.
Shackle	Used for removing and installing transmission body. NOTE: Load capacity: Use a shackle with a load capacity of 250 kg (551 lb) or more.
Dial gauge (spindle type)	Used for measuring runout of the drive plate. NOTE: Used together with the roller probe and magnet stand. Used for measuring clearance of the direct clutch flange. NOTE: Used together with magnet stand. Used for measuring the piston stroke of the reverse clutch piston. NOTE: Used together with magnet stand. Used for measuring clearance of the snap ring. NOTE: Used together with magnet stand. Used for measuring clearance of the coast clutch flange. NOTE: Used together with magnet stand. Used for measuring clearance of the forward clutch flange. NOTE: Used together with magnet stand. Used for measuring runout of the intermediate shaft. NOTE: Used together with the V-block and magnet stand.
Magnet stand	Used for measuring runout of the drive plate. NOTE: Used together with the roller probe and dial gauge (spindle type). Used for measuring clearance of the direct clutch flange. NOTE: Used together with the dial gauge (spindle type). Used for measuring the piston stroke of the reverse clutch piston. NOTE: Used together with the dial gauge (spindle type). Used for measuring clearance of the snap ring. NOTE: Used together with the dial gauge (spindle type). Used for measuring clearance of the coast clutch flange. NOTE: Used together with the dial gauge (spindle type). Used for measuring clearance of the forward clutch flange. NOTE: Used together with the dial gauge (spindle type). Used for measuring runout of the intermediate shaft. NOTE: Used together with the V-block and dial gauge (spindle type).