Initialization Procedures
CAUTION:
If the seat current position is significantly deviated from the registered position, re-register the seat and mirror face positions. If the power seat & remote control mirror control module is initialized with the position deviated, initialization may be affected by the deviation.
NOTE:
- The records inside the unit can be initialized by performing all the initialization procedures 1) to 4), irrespective of order.
- When the following conditions are met, the initialization is canceled even though the procedure is carried out halfway.
- Interval between each initialization procedure of 1) to 4) exceeds 10 seconds.
- If any of initialization procedures 1) to 4) are not performed.
- The battery runs out or the voltage to the power seat & remote control mirror control module falls out of the operation range (less than 9 V or 16 V or more) during initialization.
- Move the seat rearward using the slide switch, and keep the slide switch pressed (for approx. three seconds) until the buzzer sounds once.
- Move the seat downward using the tilt switch, and keep the tilt switch pressed (for approx. three seconds) until the buzzer sounds once.
- Move the seat downward using the lifter switch, and keep the lifter switch pressed (for approx. three seconds) until the buzzer sounds once.
- Tilt the seat back forward using the reclining switch, and keep the reclining switch pressed (for approx. three seconds) until the buzzer sounds once.
- If the initialization is completed, the buzzer sounds three times after completing the last operation and turning the switch to ON and to OFF.