FixVault
Home › Subaru › 2024 › BRZ Limited, Standard Trans › Repair and Diagnosis › Suspension › Front Suspension System And Wheel Alignment › Stabilizer › Installation › Stabilizer

Front Suspension System And Wheel Alignment: Stabilizer: Installation: Stabilizer

CAUTION: For parts which are not reusable, always use new parts.
  1. Install the stabilizer front, the rubber bushing stabilizer front, and the clamp stabilizer to the sub frame COMPL.
    CAUTION: Install the rubber bushing stabilizer front with its slit facing the front of the vehicle.

    Tightening torque: 

    Nut: 25 N.m (2.5 kgf-m, 18.4 ft-lb)

    Bolt: 75 N.m (7.6 kgf-m, 55.3 ft-lb)

  2. Using new flange bolts, install the stabilizer front and the sub frame COMPL as a unit.

    Tightening torque: 

    60 N.m (6.1 kgf-m, 44.3 ft-lb)

  3. Install the sub frame front LWR C COMPL. Ref. to FRONT SUSPENSION>SUB FRAME>INSTALLATION .
  4. Install the stabilizer link front (bottom part). Ref. to FRONT SUSPENSION>STABILIZER>INSTALLATION>STABILIZER LINK .
  5. Install the under cover front side rear.
  6. Install the under cover rear. Ref. to EXTERIOR/INTERIOR TRIM>FLOOR UNDER PROTECTOR>INSTALLATION .
  7. Install the under cover COMPL front T/M and the under cover front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
  8. Inspect the wheel alignment and adjust if necessary.
  9. Perform VSC (VDC) sensor midpoint setting mode. Ref. to VEHICLE STABILITY CONTROL>VSC (VDC) CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VSCCM & H/U)>ADJUSTMENT>VSC (VDC) SENSOR MIDPOINT SETTING MODE .
About FixVault