Vehicle Stability Control (VDC) System: General Description: Caution

When performing service operation, refer to "Repair Contents" in "General Description". Ref. to REPAIR CONTENTS>REPAIR CONTENTS .
When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.
Apply grease onto sliding or revolving surfaces before installation.
When performing work on the sensors or modules, be careful of the following.
- Before disconnecting electrical connectors, be sure to disconnect the ground terminal from the battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Do not apply any impact. If the parts are accidentally dropped, replace with a new part.
- Do not expose to high-temperature and humidity.
Refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" service information. Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Before starting works, remove dirt and corrosion around the target area.