Transmission Control Device: Installation

Install a new oil seal using ST.
NOTE: Apply CVTF to the press-fitting area.

Preparation tool:

ST: INSTALLER (18657AA000)

Courtesy of SUBARU OF AMERICA, INC.
Install the manual valve.

Courtesy of SUBARU OF AMERICA, INC.
Install the parking rod to the manual plate.

Courtesy of SUBARU OF AMERICA, INC.
Set the manual plate (B) and parking rod (C) as a set, and install the rod (A) of the manual valve.

Courtesy of SUBARU OF AMERICA, INC.
Install the shifter arm shaft.
CAUTION: Be careful not to damage the oil seal.

NOTE: Apply CVTF to the oil seal lip.

Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install a new spring pin.

Courtesy of SUBARU OF AMERICA, INC.
Install the detent spring.
NOTE: Make sure that the detent spring pin (a) is inserted in the positioning hole of the transmission case.

Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the inhibitor switch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>INHIBITOR SWITCH>INSTALLATION .
Install the oil strainer and oil pan. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>OIL PAN>INSTALLATION .
Install the parking support.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the parking pawl. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>PARKING PAWL>INSTALLATION .