Keyless Entry Control Module: Installation

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.

Install the keyless entry control module.
1. Install the keyless entry control module.
  Tightening torque:
  
  VIN: ]JF1##############[ Models and ]JF2##############[ Models
  
  13 N.m (1.3 kgf-m, 9.6 ft-lb)
  
  VIN: ]4S4##############[ Models
  
  7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
2. Connect the connector.
Install the trim panel assembly apron LH. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>INSTALLATION .
Install the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
When the keyless entry control module is replaced, register the transmitter ID. (Model with TPMS) Ref. to WHEEL AND TIRE SYSTEM>TIRE PRESSURE MONITORING SYSTEM>OPERATION .