FixVault
Home › Subaru › 2025 › Forester Wilderness › Repair and Diagnosis › External Pages › Different car › Section 12 (Airbag System) › Airbag Control Module › Installation

Airbag Control Module: Installation

WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • Control module is deformed.
    • Control module connector is damaged.
  2. Install the airbag control module.
    CAUTION: Do not reuse the bolt and nut.
    Always replace with the specified new bolts and nuts.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

  3. Install the duct rear heater front.
  4. Install the cover center socket.
  5. Install the cover center side.
  6. Install the console box assembly and the cover assembly front.

    Tightening torque: 

    Console box: 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)

  7. Install the center information display assembly. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>INSTALLATION .
  8. Install the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>CENTER GRILLE ASSEMBLY .
  9. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: After connecting the ground terminal to the battery sensor, place the select lever in the "P" position.
About FixVault