General Tool
WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
| TOOL NAME | REMARKS |
|---|---|
| Wobble extension | Used for installing the electric booster. |
| Penetration nut | Used for securing the brake disc when measuring brake disc runout.
|
| Cap | Used for brake hose installing portion of caliper body. |
| Crowfoot wrench | Used for installing the brake pipe.
NOTE:
Use Snap-on FRHM10 or FRHM12, or another manufacturer's 12-point wrench.
|
| Circuit tester | Used for measuring resistance, voltage and current. |
| Dial gauge | Used for measuring brake disc run-out. |
| Magnet stand | Used for measuring brake disc run-out. |
| Micrometer | Used for measuring the brake disc thickness. |
| Disc brake piston tool | Used for pushing back the electronic parking brake piston.
|
| Disc brake piston tool | Used for pushing back the piston. (Except for electronic parking brake) |
| Flare nut wrench | Used for removing and installing the brake pipe. |
| Hexagon wrench | Width across flat 11 mm (0.43 in)
|
| Hexagon wrench | Width across flat 7 mm (0.28 in) Used for removing and installing the electronic parking brake caliper. |
| PISTON BOOT INSTALLER | Used for installing the front caliper boot piston. Continental 03.9314-4914.1/760190 |
| PLUG BOLT (Part No. 26642AL000) | Used for preventing the brake fluid leakage or the air entry inside the caliper when disconnecting the brake hose from the electronic parking brake caliper.
NOTE:
This is the SUBARU genuine part.
|
| PLUG GASKET (Part No. 26642AL010) | Used for preventing the brake fluid leakage or the air entry inside the caliper when disconnecting the brake hose from the electronic parking brake caliper.
NOTE:
This is the SUBARU genuine part.
|