FixVault
Home › Suzuki › 2004 › Swift + › Repair and Diagnosis › External Pages › Different car › Section 21 (Antilock Brake System) › Repair Instructions › Brake Modulator Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake modulator assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the mounting bracket bolts on the hydraulic unit.

    Tighten:  Tighten the torque ABS mounting bracket bolts to 22 N.m (16 lb ft).

  3. Install the brake pipes fitting nuts from the hydraulic unit.

    Tighten:  Tighten the torque brake pipe fitting nuts to 16 N.m (12 lb ft).

  4. Connect the ABS wiring harness connector to its socket on the EBCM.
  5. Connect the negative battery cable.
    6. NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
  6. Add new brake fluid and bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.
  7. Inspect the brake system for leaks.
About FixVault