FixVault
Home › Suzuki › 2008 › Swift + › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 1.6L - Introduction (2 Of 2) › Repair Instructions › Crankshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing CKP Sensor And Bolt
    GM1289479Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the CKP sensor with the bolt.

    Tighten:  Tighten the CKP sensor bolt to 6.5 N.m (58 lb in).

    2. Fig 2: Disconnecting/Connecting Crankshaft Position Sensor
    GM1289478Courtesy of GENERAL MOTORS CORP.
  2. Connect the CKP sensor electrical connector.
  3. Connect the negative battery cable.
About FixVault