FixVault
Home › Suzuki › 2008 › Swift + › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 1.6L - Introduction (2 Of 2) › Repair Instructions › Fuel Pump Replacement › Removal Procedure

Removal Procedure

    Fig 1: Engine Fuse Box
    GM1917384Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Relieving Fuel Pressure Caution .
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
    2. Fig 2: Removing/Installing Fuel Pump Access Cover
    GM1376163Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  2. Disconnect the negative battery cable.
  3. Remove the rear seat. Refer to Rear Seat Cushion Replacement .
  4. Remove the fuel pump access cover.
    5. Fig 3: View of Fuel Tank Pressure Sensor Electrical Connector
    GM1376164Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector at the fuel pump assembly.
  6. Disconnect the fuel line.
  7. Remove the fuel pump assembly clip.
  8. Remove the fuel pump assembly from the tank.
  9. Remove and discard the gasket.
About FixVault