Precautions in Speedometer Test or Other Tests

When performing speedometer or a bench test while rotating a tire, ESP® function must be kept at stop. It is possible to stop ESP® function temporarily by ESP® OFF switch. In this case, however, the function is forced to come back to work when the speed exceeds 30 km/h (18.5 mph) and may hinder accurate testing.

There are two ways described below to stop the ESP® function completely.

• Connect the SUZUKI scan tool, select to the "ESP® Function Setting" through the "Utility", them select the "Deactivation" to stop the ESP® function. Refer to SUZUKI scan tool operator's manual for further details.
• Disconnect the connector of the steering angle sensor, and ESP® function is forced to enter the fail-safe mode, then ESP® function is stopped.

  However, when this method is used, DTC remains in the memory of the ESP® control module. Therefore, after the test, re-connect the connector, clear DTC in the memory of the ESP® control module. And calibrate steering angle sensor. Refer to SENSOR CALIBRATION OF ESP® Components .