FixVault
Home › Suzuki › 2013 › Kizashi Base, Standard Trans › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Communication System › Diagnostic Information and Procedures › Troubleshooting For Communication Bus Off › Communication Check › P/S Control Module

P/S Control Module

  1. Push engine switch to change ignition mode to "OFF".
  2. Connect "E10" connector to P/S control module.
  3. Push engine switch to change ignition mode to "ON".
  4. Select "Communication Bus Check" under "Bus Check" menu of SUZUKI scan tool.
  5. Confirm the CAN communication that control modules, sensors and P/S control module have been already connected on is in normal condition. Refer to JUDGMENT OF COMMUNICATION BUS CHECK 
  6. If any malfunction is found, substitute a known-good P/S control module and recheck DTC, see P/S CONTROL MODULE REMOVAL AND INSTALLATION .
About FixVault