Control Switch Circuit Test
- Turn ignition off and "ACCEL/RESUME" switch on. To check control switch operation, check for continuity between terminal 23 and ground. If no continuity, inspect control switch. If continuity exists, turn "ACCEL/RESUME" switch off and repeat test. If there is continuity, inspect control switch. If none, check computer.
- To check computer, turn "ACCEL/RESUME" switch on and check circuit. Check for continuity between terminal 13 and ground. If none, check for open in harness between applicable terminals above and terminal 23 of control switch.
- If continuity existed, inspect actuator operation. See ACTUATOR CIRCUIT TEST below in this article. If actuator is not normal, replace. If normal, replace computer.