Fuel Injected Models
- Engine must be at normal operating temperature. Unplug fuel injection solenoid resistor wire connector. On Van models, it is on left side of engine (under driver's seat).
- Disconnect electrical connector at cold start injector. Disconnect distributor connectors. Remove spark plugs and coil wire. Check compression with throttle wide open and engine at cranking speed.
COMPRESSION SPECIFICATIONS
| Application | Specification |
|---|---|
| Compression Ratio | 8.8:1 |
| Normal Compression Pressure | 178 psi (12.5 kg/cm2 ) |
| Minimum Compression Pressure | 128 psi (9.0 kg/cm2 ) |
| Maximum Variation Between Cylinders | 14 psi (1.0 kg/cm2 ) |