Ignition Timing

Engine must be at operating temperature. Connect timing light to engine. Connect tachometer to negative terminal of coil, engine check connector, or remove rubber cap and connect probe to service connector on distributor (if equipped). See Fig 3.
CAUTION: Some tachometers may not be compatible with ignition system. Consult tachometer manufacturer before connecting tach to system. Do not allow tachometer terminal to become grounded. This can damage igniter and/or coil.
Adjust idle speed to specifications. Install jumper wire across terminals of engine check connector (if equipped). See Fig 1.
On all other models, disconnect and plug both distributor vacuum hoses. Adjust timing by turning distributor.

Fig 1: Van Ignition Timing Adjustment

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Van Firing Order & Distributor Rotation

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

IGNITION TIMING (DEGREES BTDC @ RPM)

Timing: Vac. Plugged	Timing: Vac. Connected
8 @ 950	20 @ 950

Fig 3: Tach Hook-Up/Idle Speed & Ignition Timing Adjust

Fig 4: Ignition Timing Marks