Front Wiper Motor Test
- Connect lead from negative battery terminal to wiper motor body. Connect lead from battery positive terminal to terminal No. 2. Motor should operate at low speed. Disconnect positive lead.
- Connect positive lead to terminal No. 1. Motor should operate at high speed. If operation is not as specified, replace wiper motor.
- Ensure motor stops at correct position. Run motor at low speed. Stop motor at any position except "stop" position by disconnecting positive lead (terminal No. 4).
- Connect positive lead from battery to terminal No. 4. Connect negative lead to motor body. Install jumper wire between terminals No. 2 and 3. Motor should stop running at same position after motor operates again. Replace motor as necessary.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002