FixVault
Home › Toyota › 1994 › MR2 2.0 S › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Engine Controls - Remove/Install/Overhaul › Air Induction System › Turbocharger › Installation

Air Induction System: Turbocharger: Installation

  1. To install turbocharger, reverse removal procedure. Use NEW gaskets and "O" rings. Tighten all bolts and nuts to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article.
  2. After installing turbocharger and before installing heat insulators, slowly pour one ounce (30 cc) of clean oil into turbo oil inlet using funnel. Turn impeller wheel shaft by hand to circulate oil onto bearings. To complete installation, reverse removal procedure. Fill cooling system. Check engine oil level. Start engine and check for leaks.
About FixVault