A/T Models
- Disconnect electrical connector from Park/Neutral Position (PNP) switch, mounted on side of transmission or transaxle. Note terminal identification. See Fig 1.
- Using ohmmeter, check for continuity at specified terminals with gearshift in proper positions. See PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS table. If proper continuity cannot obtained, adjust switch. Replace switch if proper continuity cannot be obtained.
PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS
| Application & Gearshift Position | Terminal Continuity |
|---|---|
| Park | 5 & 6, 2 & 7 |
| Reverse | 2 & 8 |
| Neutral | 5 & 6, 2 & 9 |
| Drive | 2 & 10 |
| 2 | 2 & 3 |
| Low | 2 & 4 |