Power Mirror Switch Test
NOTE:
Mirror motor connectors may vary in configuration from vehicle to vehicle of the same model.
Remove power mirror switch. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Using ohmmeter, check continuity between appropriate mirror switch terminals. Continuity should exist between specified terminals. See POWER MIRROR SWITCH CONTINUITY TEST table. See Fig 1 and Fig 2 . If switch fails any test, replace switch.
POWER MIRROR SWITCH CONTINUITY TEST
| Application | Terminals No. | |
|---|---|---|
| Switch In Off Position | ||
| Up | 7 & 8 | |
| Down | 8 & 10 | |
| Left | 7 & 8 | |
| Right | 8 & 10 | |
| Switch In Left Position | ||
| Up | 2 & 10; 7 & 8 | |
| Down | 2 & 7; 8 & 10 | |
| Left | 3 & 10; 7 & 8 | |
| Right | 3 & 7; 8 & 10 | |
| Switch In Right Position | ||
| Up | 5 & 10; 7 & 8 | |
| Down | 5 & 7; 8 & 10 | |
| Left | 4 & 10; 7 & 8 | |
| Right | 4 & 7; 8 & 10 | |