Clearing Codes
CAUTION:
DO NOT disconnect vehicle battery to clear codes.
- To clear codes from cruise control ECU memory, locate DLC No. 1 in right side of engine compartment, near shock tower. Connect a jumper wire between terminals E1 and Tc at DLC No. 1. See Figure. Road test vehicle at 9 MPH or less. Holding cruise control switch in CANCEL position, depress cruise control ON-OFF (main) switch to ON position 5 times within 3 seconds.
- Fault codes are now erased from cruise control ECU memory. If problem has not been corrected or fault is still present, code will reset in cruise control ECU memory.