RS-3000 Features

RS-3000 FEATURES

FEATURES	FUNCTIONS
REMOTE ARMING/DISARMING	The RS3000 may be ARMED and DISARMED with either of the supplied REMOTE CONTROLS. If the vehicle is equipped with power locks, the doors are locked when the system is ARMED and unlocked when it is DISARMED.
PASSIVE (AUTOMATIC) ARMING	The RS3000 may be programmed to automatically ARM and protect the vehicle 15 seconds after the ignition key is removed, the vehicle exited, and the last door or trunk (or hatch) is closed.
PASSIVE DISARMING	The RS3000 may be DISARMED with the vehicle's ignition key when the system was PASSIVELY ARMED.
VALET MODE	The RS3000 allows the user to suspend security functions, enter and exit the vehicle without the system PASSIVE ARMING or TRIGGERING, and to use the REMOTE CONTROLS just to lock and unlock the doors. (PANIC MODE still works, though. )
PANIC MODE	The user may draw attention to the vehicle by depressing the top button on the REMOTE CONTROL for over 2 seconds. When this mode is activated, the lights flash and the horn sounds for 57 seconds, or until PANIC MODE is deactivated. This mode may be activated at any time.
POINT-OF-ENTRY PROTECTION	The RS3000 will TRIGGER if a door, trunk or hatch is opened while the system is ARMED. (If the system was PASSIVE ARMED, the ENTRY DELAY must pass before TRIGGERING occurs. )
GLASS BREAKAGE SENSOR	The RS3000 uses a microphone mounted in the STATUS MONITOR to sense the noise from tapping on window glass, or glass breakage, and TRIGGER the system. It is fine tuned to "listen" for this type of noise, and ignore other sounds.
STATUS MONITOR	This panel houses the GLASS BREAKAGE SENSOR microphone, and the flashing LED light that indicates the operating status of the security system.
STARTER DISABLE	When the RS3000 is TRIGGERED, it disables the vehicle's starter, and prevents engine start until the system is reset.
AUTOMATIC RE-ARMING AND RE-LOCKING	The RS3000 will automatically RE-ARM, and RE-LOCK the doors after it is REMOTE DISARMED, when no door, trunk or hatch is opened within 30 seconds after disarming.
AUTOMATIC DOOR LOCKING/UNLOCKING (For vehicles equipped with power door locks)	The RS3000 is programmed to automatically LOCK all of the vehicle's doors when the ignition key is turned to "ON" or "START", and UN LOCK them when the key is turned back to "ACC" or "LOCK".
PIEZO "CHIRPER"	This device produces a soft "chirp" sound when the RS3000 is ARMED or REMOTE DISARMED. It also produces sound for the DOOR AJAR WARNING, and chirps to confirm function programming changes.
DOOR AJAR WARNING	The PIEZO "CHIRPER" emits a continuous sound for up to 10 seconds when the user attempts to REMOTE ARM the system while a door, trunk or hatch is open.
INTERIOR LIGHT ACTIVATION	The vehicle's interior lights turn on for 3 seconds after REMOTE ARMING, for 30 seconds after REMOTE DISARMING, and flash in a unique pattern while the system is TRIGGERED.
EXTERIOR LIGHT ACTIVATION	The RS3000 flashes the exterior (tail and marker) lights during PASSIVE and REMOTE ARMING, REMOTE DISARMING, and flashes them in a unique pattern when the system is TRIGGERED or in the PANIC MODE.
HORN ACTIVATION	While TRIGGERED or in PANIC MODE, the RS3000 sounds the vehicle's horn in a unique pattern.
NOISE ABATEMENT	When TRIGGERED, the RS3000 will sound the vehicle's horn for 57 seconds (one cycle). It will not sound the horn for more than ten consecutive cycles.
TRIGGER MEMORY	The user is notified that the RS3000 was TRIGGERED and reset. When REMOTE DISARMING, the exterior lights flash 3 times, instead of the normal 2 times. When PASSIVE DISARMING (by key), the exterior lights flash 3 times when the ignition switch is turned to "ON".
POWER LOSS MEMORY	If power in the vehicle is lost while the RS3000 is ARMED, the system will TRIGGER when power is restored.
TWO BUTTON, THREE CHANNEL REMOTE CONTROLS	Top button: Primary vehicle Bottom button: Second vehicle equipped with a 1998 model RS3000 Security System.
PROGRAMMABLE REMOTE CONTROL CODES	The RS3000 REMOTE CONTROL is programmed from a pool of 2,000,000 possible transmitting code combinations, preventing generic remote control operation of your system. The RS3000 can be easily programmed to operate with up to 4 different REMOTE CONTROLS, depending on system configuration.
VEHICLE-SPECIFIC INSTALLATION	The RS3000 was designed specifically for your Toyota vehicle, and is built to the same exacting standards applied to every genuine Toyota component.