Section 274 (Charging System): Generator: Removal

WARNING: This page is about a different car, the 2002 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE DRIVE BELT

Fig 1: Removing Drive Belt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Loosen the pivot bolt, adjusting lock bolt and adjusting bolt, and remove the drive belt.
1. Torque:
  1. Pivot bolt: 56 N.m (570 kgf.cm, 41 ft.lbf)
  2. Lock bolt: 18 N.m (180 kgf.cm, 13 ft.lbf)
REMOVE GENERATOR
1. Disconnect the generator connector.
2. Remove the nut, and disconnect the generator wire.
3. Disconnect the wire harness from the clip.