Inspection Procedure

Check: 

Check continuity of PWR1, AM1 and DOME fuse.

OK: 

Continuity

NG: Replace the failure fuse  .

OK: Go to Next Step 

Preparation: 

Turn ignition switch ON.

Check: 

Measure voltage between terminals IG, and GND.

OK: Voltage: 10 - 14 V 

Preparation: 

1. Turn ignition switch OFF.
2. Disconnect the driver door ECU connector.

Check: 

Measure voltage between terminals B, CPUB and GND.

OK: Voltage: 10 - 14 V 

OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  )  .

NG: Go to Next Step 

NG: Repair or replace wireharness or connector 

OK: Check and repair wireharness and connector between ECU and battery  .