FixVault
Home › Toyota › 2001 › Prius › Repair and Diagnosis › Transmission › Transmission Control Systems › Transmission Control System Transaxle › Differential Oil Seal › On-Vehicle Repair

On-Vehicle Repair

  1. REMOVE ENGINE UNDER COVER LH AND RH 
  2. DRAIN TRANSAXLE OIL (See page ON-VEHICLE REPAIR )
  3. REMOVE FRONT DRIVE SHAFT (See  ECHO & PRIUS  ) 
  4. REMOVE DIFFERENTIAL OIL SEAL LH AND RH 

    Using SST, pull out the 2 oil seals. SST 09308-00010

    Fig 1: Removing Differential Oil Seal LH And RH
    G03452717Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL DIFFERENTIAL OIL SEAL LH AND RH 
    1. Using SST and a hammer, drive in 2 new oil seals. SST 09350-32014 (09351-32130, 09351-32150)
      Fig 2: Installing Differential Oil Seal LH And RH
      G03452718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Oil seal depth: 2.7 +/- 0.5 mm (0.11 +/- 0.02 in.) 

    2. Coat the lip of the 2 oil seals with MP grease.
  6. INSTALL FRONT DRIVE SHAFT (See  REASSEMBLY  ) 
  7. ADD TRANSAXLE OIL (See ON-VEHICLE REPAIR )
  8. CHECK TRANSAXLE OIL LEVEL (See page ON-VEHICLE REPAIR )
  9. INSTALL ENGINE UNDER COVER LH AND RH 
  10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT (See  WHEEL ALIGNMENT PROCEDURES  ) 
About FixVault