FixVault
Home › Toyota › 2002 › 4Runner Base › Repair and Diagnosis › External Pages › Different car › Section 271 (Engine Lubrication System) › Oil Pump › Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2004 Toyota MR2, 2003 Toyota MR2, and 2002 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OIL PUMP 
    1. Place a new gasket on the cylinder block.
    2. Engage the spline teeth of the oil pump drive rotor with the large teeth of the crankshaft, and slide the oil pump.
      3. Fig 1: Installing Oil Pump
      G01087965Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the oil pump with the 5 bolts.

    Torque: 9 N.m (92 kgf.cm, 80 in.lbf) 

  2. INSTALL CRANKSHAFT TIMING SPROCKET AND TIMING CHAIN  . INSTALLATION .
  3. FILL ENGINE WITH OIL 
  4. START ENGINE AND CHECK FOR LEAK 
  5. RECHECK ENGINE OIL LEVEL 
About FixVault