Power Door Lock Control System: Pre-Check

USING HAND-HELD TESTER
1. Hook up the hand-held tester to the DLC3.
2. Monitor the ECU data by following the prompts on the tester screen.
NOTE: Hand-held tester has a "Snapshot" function which records the monitored data.

Refer to the hand-held tester operator's manual for further details.
DTC CLEAR
1. The DTCs and freeze frame data will be erased by the hand-held tester to erase the codes.

DATA LIST

HINT:

According to the DATA LIST displayed by the OBD II scan tool or hand-held tester, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as a first step of troubleshooting is one of the method to shorten the labor time.

Connect the OBD II scan tool or hand-held tester to the DLC3.
Turn the ignition switch ON.

According to the display on tester, read the "DATA LIST".

Standard (Body ECU):

POWER DOOR LOCK CONTROL SYSTEM CONDITION

Item	Measurement Item/Display (Range)	Normal Condition	Diagnostic Note
KEYSW	Key Unlock Warning SW Signal/ON Or OFF	ON: Key Is IG Key Cylinder OFF: Key Is Not In IG Key Cylinder	.....