Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: In case of using the TOYOTA hand-held tester, start the inspection from step 1 and in case of not using the TOYOTA hand-held tester, start from step 2.

Check parking brake switch using TOYOTA hand-held tester.
Preparation : connect the TOYOTA hand-held tester to the DLC 3.

Check : the parking brake switch using DATA LIST.
1. OK : Proceed to next circuit inspection shown in problem symptoms. See PROBLEM SYMPTOMS .
2. NG : Go to step 2.
Check parking brake switch . See INSPECT PARKING BRAKE SWITCH .
1. NG : Replace the parking brake switch.
2. OK : Go to step 3.
Check wire harness and connector between parking brake switch and body ECU . See HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS .
1. NG : Repair or replace wire harness or connector.
2. OK : Proceed to next circuit inspection shown in problem symptoms. See PROBLEM SYMPTOMS .