Section 41 (Manual A/C-Heater Systems): Receiver: Removal

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

Discharge refrigerant from refrigeration system.
NOTE: At the time of the installation, please refer to the following item.
Evacuate air from refrigeration system.

Charge system with refrigerant and inspect for leakage of refrigerant.

Specified amount: 600 +/- 50 g (21.16 +/- 1.76 oz.)
Disconnect 2 liquid tubes from receiver.
Remove the 2 bolts and disconnect the both tubes.

Fig 1: Locating Bolts For Removal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

CAUTION: Cap the open fittings immediately to keep moisture or dirt out of the system.

NOTE: At the time of the installation, please refer to the following item. Lubricate 2 new O-rings with compressor oil and install them to the tubes.
Remove receiver.
1. Remove the holder bolt and pull receiver downward.
  NOTE: At the time of the installation, please refer to the following item.
  If receiver is replaced, add compressor oil to compressor.
  Add 20 cc (0.71 fl.oz.)
  
  Compressor oil: ND-OIL 8 or equivalent
2. Remove the bolt and holder.