Driver-side AIR Bag Module
WARNING: This page is about a different car, the 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. Install 2 bolts (6 mm X 35 mm) with washers into holes located in rear of driver-side air bag module. Tighten bolts by hand. DO NOT overtighten bolts.
- Wrap strong wire at least twice around each bolt. See Fig 1. Ensure no slack is present in wire. If slack is present, or wire is not strong enough, driver-side air bag module may become loose due to shock when air bag is deployed.
- Position driver-side air bag module on rim of a scrap wheel and tire assembly with pad side facing upward. See Fig 2. Securely tie driver-side air bag module to wheel rim through lug nut holes. Place a large cardboard box (weighted at sides) or 3 scrap tires on top of driver-side air bag module.
- Connect Deployment Tool (09082-00700 and 09082-00760) to driver-side air bag module connector. Position deployment tool at least 33 feet (10 m) away from driver-side air bag module. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Press activation switch to deploy driver-side air bag module. Because of heat, wait 30 minutes before handling driver-side air bag module.