FixVault
Home › Toyota › 2003 › Matrix Base, FWD, Standard › Repair and Diagnosis › External Pages › Different car › Section 354 (Driver Door Control System - Diagnostics) › Circuit Inspection › Window lock switch circuit › Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the window lock switch circuit using DTC check (See  HOW TO PROCEED WITH TROUBLESHOOTING  ). 
    1. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  or  PROBLEM SYMPTOMS TABLE  ). 
    2. NG : Go to Next Step 
  2. Check wire harness and connector between driver door ECU and passenger door ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG : Repair or replace wire harness or connector. 
    2. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
About FixVault