Back Door Glass: Removal

REMOVE BACK DOOR TRIM BOARD

Fig 1: Removing Back Door Trim Board
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, remove the back door trim board.

NOTE: Tape the screwdriver tip before use.
REMOVE STOP LIGHT COVER

Fig 2: Removing Stop Light Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, remove the stop light cover.

NOTE: Tape the screwdriver tip before use.
REMOVE UPPER SIDE GARNISHES

Fig 3: Removing Upper Side Garnishes
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, remove the upper side garnishes.

NOTE: Tape the screwdriver tip before use.
REMOVE STOP LIGHT
REMOVE WIPER ARM
REMOVE BACK DOOR MOULDING

Fig 4: Removing Back Door Moulding
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using a knife, cut off the moulding as shown in the illustration.
  NOTE: Do not damage the body with the knife.
2. Remove the remaining moulding.
REMOVE BACK DOOR GLASS

Fig 5: Removing Back Door Glass
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Push a piano wire through between the body and glass from the interior.
2. Tie both wire ends to wooden blocks or similar objects.
  NOTE: Apply protective tape to the outer surface to keep the surface from being scratched.
  
  NOTE: When scraping the glass, take care not to damage the paint and interior and exterior ornaments.
3. Cut the adhesive by pulling the piano wire around it.
4. Remove the glass.
NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.