Tilt Steering Column: Inspection

Inspect Steering Lock Operation
Check that the steering lock mechanism operates properly.
If Necessary, Replace Key Cylinder
1. Place the ignition key at the ACC position.
  
  Fig 1: Placing Ignition Key At ACC Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Push down the stop pin with a screwdriver, and pull out the cylinder.
3. Install a new cylinder.
  NOTE: Make sure the key is at the ACC position.
Inspect Ignition Switch (See INSPECTION )
If Necessary, Replace Ignition Switch
1. Remove the 2 screws and ignition switch from the column upper bracket.
2. Install a new ignition switch with the 2 screws.
  Torque: 2.2N.m (20kgf.cm, 17in.lbf)
Inspect Key Unlock Warning Switch (See INSPECTION )
If Necessary, Replace Key Unlock Warning Switch
1. Slide the key unlock warning switch out of the column upper bracket.
2. Slide a new key unlock warning switch in the column upper bracket.
Inspect Transponder Key Coil (See INSPECTION )
If Necessary, Replace Transponder Key Coil
If Necessary, Replace Transponder Key Amplifier
1. Remove the 2 screws and transponder key amplifier.
2. Install a new transponder key amplifier with the 2 screws.
Inspect Bearing
1. Check the bearing rotation condition and check for abnormal noise.
  If the bearing is worn or damaged, replace the column tube.
  
  Fig 2: Inspecting Bearing For Wear & Damage
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the bearing rotation condition and check for abnormal noise.
  
  Fig 3: Checking Bearing Rotation Condition & For Abnormal Noise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  If the bearing is worn or damaged, replace the column tube.