VSV For Evaporative Emission (EVAP): Inspection

REMOVE V-BANK COVER
REMOVE VSV
INSPECT VSV
1. Inspect the VSV for open circuit.
  Using an ohmmeter, check that there is a continuity between the terminals.
  
  Resistance: 30 - 34 Ω at 20°C (68°F)
  
  If there is no continuity, replace the VSV.
  
  Fig 1: Inspecting VSV For Open Circuit
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Inspect VSV for ground.
  Using an ohmmeter, check that there is no continuity between each terminal and the body.
  
  If there is a continuity, replace the VSV.
  
  Fig 2: Inspecting VSV For Ground
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Inspect the VSV operation.
  1. Check that air dose not flow from the ports.
    
    Fig 3: Inspecting VSV Operation
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Apply the battery positive voltage across the terminals.
  3. Check that air flows from the ports.
    If operation is not as specified, replace VSV.
REINSTALL VSV
REINSTALL V-BANK COVER

Fig 4: Applying Battery Positive Voltage Across Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002