FixVault
Home › Toyota › 2004 › Matrix Base, 4WD › Repair and Diagnosis › Accessories & Equipment › Infotainment › Navigation System - Diagnostics › Map Disc Cannot Be Inserted › Inspection Procedure

Inspection Procedure

  1. INSPECT NAVIGATION RECEIVER ASSY (B,ACC,E) 
    1. Remove the navigation receiver assy and disconnect the connector.
    2. Check voltage.
      1. Measure voltage between terminals B, ACC and E of navigation receiver assy at each conditions, as shown in TERMINAL CONDITIONS .
        Fig 1: Locating ACC (+), B (+) And E (-) Connector Terminals
        G02915900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Standard: 

        TERMINAL CONDITIONS

        Terminal Condition Voltage (V)
        B <=> E Constant 10 - 14
        ACC <=> E Turn ignition switch ACC 10 - 14
    3. Check continuity.
      1. Check that the continuity exists between terminal E of navigation receiver assy and body ground.

        Standard: Continuity exists. 

    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: CHECK AND REPLACE NAVIGATION RECEIVER ASSY 
About FixVault