FixVault
Home › Toyota › 2004 › Matrix Base, 4WD › Repair and Diagnosis › External Pages › Different car › Section 358 (Automatic Transmission Servicing) › Removal & Installation › Output Speed Sensor › Installation

Output Speed Sensor: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify O-ring is installed into position. See Figure .
  2. Install and tighten input speed sensor to 20 ft. lbs. (27 N.m).
  3. Connect speed sensor connector. See Figure .
  4. Connect battery negative cable.
About FixVault