FixVault
Home › Toyota › 2004 › Matrix Base, 4WD › Repair and Diagnosis › External Pages › Different car › Section 949 (Power Door Locks) › Driver Cylinder Lock Switch › Installation

Driver Cylinder Lock Switch: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the switch on the key cylinder in the door handle. Ensure that switch is in 12 O'clock position.
  2. Route wire down through link rods.
  3. Install three clips to security shield.
  4. Connect wire harness connector.
  5. Install the door trim panel (Refer to TRIM PANEL ).
  6. Connect the battery negative cable.
  7. Verify system operation.
About FixVault